Search results for: 'hire for self dump creek punta good fl'

Capacity: 15,000 Litre Quantity: 15 Above Ground Waste Sumps / Tanks Location: New South Wales, Australia Learn More

Air Core Drill Rig - New Comp Rotation Head - Deck Engine - Main Feed Ram - Radiator Hydraulic Pump - Tilting Rod Bin - Onboard Air Compressor Hours: 100 Approx. Compressor Capacity: 600 CFM / 230 PSI - Cradle for Cyclone Pump points for Booster Bean Pump - Dump Mast - Has been water boring for the last 5 years - Too many spares to list Truck Make: Hino Model: GT Year: 2014 KM's: 64,000 Type: 4x4 Truck Mounted Drill Rig Location: Queensland, Australia Learn More

Sizes: 3" Inch / 4" Inch / 5" Inch Working Pressure: 2,500 PSI - Basic Hard Shut in Nitrile Bladder - Wireline Stripper - Hydraulic Activator - Hand Pump Activator - All Hoses Burst Protection or Fire Protected - Zone One Hoses are Coflexip and Armour Plated - Casing Adaptor to be purchased Annular Diverter Location: Queensland, Australia Learn More

- Fully Hydraulically Operated - No Electrics - Various API Screen Sizes available - 600 GPM Jack Up Rod Sloop Mounted Shale Shaker Location: Queensland, Australia Learn More

Model: HT400 Engine: Cummins Transmission: Alison Gearbox - Variable Speed - 450 to 500 GPM Skid Mounted Triplex Mud Pump Location: Queensland, Australia Learn More

Rig Make: UDR Model: 650 Onboard Compressor: Sullair 1,150 CFM / 350 PSI Air Compressor - Set up for Waterbores, RC and Aircore - Table opens up to allow 14” inch casing or bit - Recent major service of Air End, Separator Filter & New Oil - New Head Slides - New Jib Ram - New Pull Down Ropes - Head Serviced Includes; - Cyclone & Splitter - New Bull Hose - 25x Used 4” Inch RC Rods with Inner Tubes - 2x Head Tubes - Air RC Swivel - Mud Rotary Swivel - Hydraulic Breakout Arm - 4” Inch Airdrill RC Hammer (in Good Condition) & 2x Hammer Tubes - 7x 5” Inch Hammer Bits (Used) - 1x 4” Inch Back Hammer - 1x 8” Inch Aircore Bit - 4” Inch Aircore Bits (2x New & 3x Used) - Blow Up Sub - 1x 4 ½” Inch PDC Bit - 6” Inch Casing Elevator Set - Diverter Box with 20x Rubbers - Stuffing Box - Rod Spanner to suit - Dig Out Sub Rig Truck Make: Volvo Year: 2012 - Twin Steer Option 1 – Water Bore Drilling Equipment (Additional $15,400 ex GST) - 12” Inch Blade Bit (Near New) - 7 7/8” Inch Blade Bit - 8” Inch Tri-Cone Med Formation (Near New) - 6” Inch Shreps Hammer with 6” Inch & 8” Inch Bits (New) - Adaptor Subs to suit - Rod Spanners to suit - Casing Elevators Option 2 – RC Rods (Additional $55,000 ex GST) - 180 Metres of RC 4” Inch Remet Rod String (New) Option 3 – Hooklift Truck + Bins ($55,000 ex GST) Truck Make: Isuzu Year: 2000 - Hooklift Truck Bins; 1st Bin: 6x5 Gardner Denver Mud Pump with Perkins Engine 2nd Bin: To carry PVC and Gravel 3rd Bin: To carry Water Suttles Truck Mounted Drill Rig Location: Queensland, Australia Learn More

Rig Make: Mayhew Model: 1000 Hours: 16,000 Rig Truck Make: Mack Model: Quantum Year: 2005 KM's: 750,000 Includes; - Onboard Sullair 350/750 Air Compressor (Low Hour) - Onboard 5/4 Mud Pump - 4 Pot Bean Pump - GD 2000 Table - Mayhew 1000 Draw Works - 4 Long Stroke Jacks - All Powered off Truck Engine - All Variable Speed Hydraulic Drive - Isolators - Mine Spec - Excellent Tyres - Air Conditioning - 2 UHF Radio - Jump Start - E Stop - Isolators - Plastic Rollover Guards - Good Rubber Skirting Under Table - 2 Tool Boxes - Fire Extinguisher - All service records available - Rig has had extensive rebuilds every second year Support Truck Make: Volvo Model: FL10 Year: 1995 Includes; - Holds 6,500 L of Water - Jump Start, E Stop, Isolators - Ample Toolboxes, Storage - Slide Out Safety Rails - Storage on Top of Water Tank - Spare Tyre Tracks - All New Paint - New Drive Tyres, Steer Good Tyres - Certified ROPS - Air Conditioning - UHF Radios - Fire Extinguisher - Hydraulic Water Pump - Can hold 90 m 5" Inch PVC & Plenty of Rods Compressor Make: Sullair Model: 350/1100 or 500/900 Year: 2006 Hours: 2,000 - Computerised CAT C15 Manual Sullair Control System - Split Intercooler & Compressor Oil Cooler Mounting - Cabinet Braces - Receiver Bracing - Remote E Stop - Jump Start Receptacle - Isolators, Mine Spec - Connected to 4,000 L Diesel Fuel Tank underneath (Can pump diesel out of bulk tank) Truck Mounted Drill Rig & Support Truck Package Location: Queensland, Australia Learn More

Drill Rig Make: American Augers Model: DD140 Control Room Capacity: 20’ Foot Storeroom Capacity: 10’ Foot Genset Make: Kubota Model: GL9000D-AU-B Serial No: K10450 Capacity: 9kVA Control Room Trailer Make: Krueger Model: ST338 Year: 2008 ATM: 38 Tonne VIN: 6FH9079AB8M012264 - Trailer Pipe Handler Trailer Make: Gallagher Year: 2024 Max. Lifting Capacity: 1,100 kg - Purpose built Tandem Axle Trailer on airbag suspension with EBS braking - 4x Hydraulic Jack Legs - Self-Contained other than using the DD140 Auxiliary Hydraulics - Can present Horizontal Rod/Casing/BHA from a rod bench & install into the machine - Supplied with requested dies to suit rods, casing & BHA equipment - Full operational dash, with E-Stops on various positions - Complete working deck between the rig & road loader Including; - Rig Sub Base and Drill Floor Not Included; - Koomey Unit (in Photos) Track Mounted Drill Rig Package Location: Queensland, Australia Learn More

Make: Caterpillar Model: C15 Year: 2006 Hours: 1,533 • 440 HP @ 2,100 RPM • 1482LB-FT @ 1,400 RPM • Air to Air intercooled • 12 Volt (We can covert to 24 Volt if required) • SAE #1 flywheel housing multi fit industrial flywheel. • If required, we can supply and install a Caterpillar Air Compressor to the motor which runs off the auxiliary drive. The motor has been removed from the unit and fully workshop inspected and run up under load on the Dyno, results are as follows: Workshop inspection: • Intake manifold clean. • Cylinder head and rocker gear clean, no moisture or sludge, tune ok. • Turbocharge in nice condition, no excessive shaft play. • Camshaft in nice condition, no pitting • Crankshaft in good condition (Standard) • Main bearings and Con rod bearings in good condition – minimal wear • Crankshaft end float within spec Load test Report • Oil pressure: Cold Idle 70psi / Cold Top Revs 85psi / Hot Idle 50psi / Hot Top Revs 75psi • Water temps: Top Radiator 92 degrees. Bottom Radiator 69 degrees. • Thermostat opened and engine recovered correctly. • Turbocharger boost: 23 PSI @ 2,100 RPM • Breathing/ Blow by: 20 mm @ idle 30 mm @ 1,200 RPM 50 mm @ 1,350 RPM. 120 mm @ 1,800 RPM. • Smoke condition: small amount of black on startup, none at idle and very small white under full load. Skid Mounted Engine Location: Queensland, Australia Learn More

Rig Year: 2007 Hours: 3,000 Engine: Caterpillar (85 HP) Stroke: 3,300 mm - 2 Speed Head Rotation Torque: 2,500/450 Nm Rotation Speed: 140/750 RPM Pullback: 7,000 kg Pull Down: 4,000 kg - Set up for Geotechnical Drilling with Auto SPT - 1x Main Winch - 2x Wireline Winch - Mono Pump - Four Jack Legs - Drilling Rods, Alloy Mud Tanks, Accessories for 50 m (All in Good Condition) Truck Make: Isuzu Model: FTS 750 Year: 2007 KM's: 55,000 Type: 4x4 Table Top Truck Mounted Drill Rig Location: Queensland, Australia Learn More

Rig Model: ZJ50D/3150 Year: 2012 Mast Model: JJ315/45-K6 Substructure Model: DZ3159-S Drawworks Model: JC50D Power: 1,500 HP Rotary Table Model: ZP-375 Full Opening: 37.5” Inch Rotary Speed: 300 RPM Mud Pump Power: 1,600 HP Stroke: 120 RPM Working Pressure: 5,000 PSI Quantity: 2x Mud Tank Shaker Tank: 25 CuM Intermediate Tank: 40 CuM Suction and Mixing Tank: 20 CuM Solids Control - 3x Shale Shaker - 1x Mud Cleaner - 1x Centrifuge Drill Rig Location: Japan Learn More

Make: Komatsu Model: HD465-7E0 Year: 2021 Hours: 9,000 - 17,280 Quantity: 10 Dump Trucks Location: China Learn More

Make: Caterpillar Model: 745 Year: 2018 & 2019 Quantity: 3x 2019 / 5x 2018 - No EPA or CE Condition: Excellent & Good Tyres Dump Trucks Location: Chile Learn More

Make: Atlas Copco Model: RD20-III Year: 2007 Hours: 7,500 - In Good Working Order - Full Service Report Available This used 2007 RD20 Range III Atlas Copco Rig is a powerful and versatile drilling machine, ideal for a wide range of applications. Equipped with on IR 1,250 CFM / 350 PSI Air Compressor, this rig delivers exceptional performance and efficiency. Powered by a robust CAT C13 engine, the rig ensures smooth operation and ample power. The Cummins QSK19 deck engine further enhances its performance capabilities, delivering 755 HP for demanding drilling tasks. With a substantial pullback capacity of 120,000 lbs (54,446 kg), this rig can handle tough drilling conditions with ease. Mounted on a crane carrier truck, this RD20 III Atlas Copco Rig provides excellent mobility and stability. The rig has been meticulously maintained to ensure optimal condition and longevity. Its clean appearance reflects the owner’s commitment to proper care and maintenance. Carrier Mounted Drill Rig Location: New South Wales, Australia Learn More

Make: SPM Weir Model: TWS2250 Year: 2022 (Reman Rebuild) Hours: Approx. 7,000 Engine: Caterpillar CAT C32 (Rated @ 1,350 HP) Transmission: Allison 8000 Series Auto (DP8962R) Dimensions; Length: 9,135 mm (Overall) Width: 2,505 mm Height: 2,615 mm (On Ground) Height: 4,280 mm (Raised) Weight: 20,000 kg - When raised has enough height for a trailer of 1,500 mm to drive underneath Skid Mounted Jack Up Frac Mud Pump Location: Queensland, Australia Learn More

Make: Sandvik Model: DC302R Year: 2013 Hours: 6,030 Engine Power: 62 kW Drifter: HL300 (8 kW) - Fully Reconditioned and Painted Self Propelled Drill Rig Location: Europe Learn More

Rig Make: Hydramaster Model: 2000 - Fully Tooled & Spares - Recently painted Truck Make: International Model: Acco Year: 1998 KM's: 506,309 Type: 4x2 Engine: Cummins 300 HP Gearbox: 9 Speed Tri Axle Trailer - Near New - Set up for cable tool equipment Condition: Good Truck Mounted Cable Tool Drill Rig Tri Axle Trailer Location: Queensland, Australia Learn More

Make: Komatsu Model: HD465-7E0 Year: 2012 Hours: 10,604 Dump Truck Location: Chile Learn More

Make: Komatsu Model: HD465-7E0 Year: 2012 Hours: 7,883 Dump Truck Location: Chile Learn More

Make: Komatsu Model: HD465-7E0 Year: 2012 Hours: 9,534 Dump Truck Location: Chile Learn More