Search results for: 'hole for skid 1998'
- Did you mean
- hire for skid 1998
- Related search terms
- hole to enabl 100 hz and adaptive sale
- hole for sale in carry hire nj
- hole for sale in cargo hire nj
- hole for sale in cherry hire nj
- hole to enabl 100 hz and adaptive seal
-
2006 Caterpillar CAT C15 Skid Mounted Engine ($59,000 ex GST) (sale-ehub4016)For Sale$59,000.00Make: Caterpillar Model: C15 Year: 2006 Hours: 1,533 • 440 HP @ 2,100 RPM • 1482LB-FT @ 1,400 RPM • Air to Air intercooled • 12 Volt (We can covert to 24 Volt if required) • SAE #1 flywheel housing multi fit industrial flywheel. • If required, we can supply and install a Caterpillar Air Compressor to the motor which runs off the auxiliary drive. The motor has been removed from the unit and fully workshop inspected and run up under load on the Dyno, results are as follows: Workshop inspection: • Intake manifold clean. • Cylinder head and rocker gear clean, no moisture or sludge, tune ok. • Turbocharge in nice condition, no excessive shaft play. • Camshaft in nice condition, no pitting • Crankshaft in good condition (Standard) • Main bearings and Con rod bearings in good condition – minimal wear • Crankshaft end float within spec Load test Report • Oil pressure: Cold Idle 70psi / Cold Top Revs 85psi / Hot Idle 50psi / Hot Top Revs 75psi • Water temps: Top Radiator 92 degrees. Bottom Radiator 69 degrees. • Thermostat opened and engine recovered correctly. • Turbocharger boost: 23 PSI @ 2,100 RPM • Breathing/ Blow by: 20 mm @ idle 30 mm @ 1,200 RPM 50 mm @ 1,350 RPM. 120 mm @ 1,800 RPM. • Smoke condition: small amount of black on startup, none at idle and very small white under full load. Skid Mounted Engine Location: Queensland, Australia Learn MoreMachine hours 1,400
KILOMETERS N/A YEAR 2006
BRAND Caterpillar CAT
LOCATION Queensland, Australia
MODEL C15
-
Tulsa Triplex TT-560 Skid Mounted Triplex Mud Pump (POA) (sale-ehub3995)For Sale$0.00Make: Tulsa Triplex Model: TT-560 Engine: Caterpillar CAT C15 Skid Mounted Mud Pump Location: New Zealand Learn MoreMachine hours N/A KILOMETERS N/A YEAR N/A BRAND N/A
LOCATION New Zealand
MODEL TT-560
-
Baoji Oilfield Machinery F-800 Skid Mounted Mud Pump (POA) (sale-ehub3993)For Sale$0.00Make: Baoji Oilfield Machinery Model: F-800 Skid Mounted Mud Pump Location: New Zealand Learn MoreMachine hours N/A KILOMETERS N/A YEAR N/A BRAND N/A
LOCATION New Zealand
MODEL F-800
-
2022 Rebuilt SPM Weir TWS2250 Skid Mounted Jack Up Frac Mud Pump (FOR HIRE/RENT - POA) (hire-ehub3982)For Sale$0.00Make: SPM Weir Model: TWS2250 Year: 2022 (Reman Rebuild) Hours: Approx. 7,000 Engine: Caterpillar CAT C32 (Rated @ 1,350 HP) Transmission: Allison 8000 Series Auto (DP8962R) Dimensions; Length: 9,135 mm (Overall) Width: 2,505 mm Height: 2,615 mm (On Ground) Height: 4,280 mm (Raised) Weight: 20,000 kg - When raised has enough height for a trailer of 1,500 mm to drive underneath Skid Mounted Jack Up Frac Mud Pump Location: Queensland, Australia Learn MoreMachine hours Approx. 7,000
KILOMETERS N/A YEAR N/A BRAND N/A
LOCATION Queensland, Australia
MODEL SPM Weir TWS2250
-
2022 Rebuilt SPM Weir TWS2250 Skid Mounted Jack Up Frac Mud Pump (POA) (sale-ehub3982)For Sale$0.00Make: SPM Weir Model: TWS2250 Year: 2022 (Reman Rebuild) Hours: Approx. 7,000 Engine: Caterpillar CAT C32 (Rated @ 1,350 HP) Transmission: Allison 8000 Series Auto (DP8962R) Dimensions; Length: 9,135 mm (Overall) Width: 2,505 mm Height: 2,615 mm (On Ground) Height: 4,280 mm (Raised) Weight: 20,000 kg - When raised has enough height for a trailer of 1,500 mm to drive underneath Skid Mounted Jack Up Frac Mud Pump Location: Queensland, Australia Learn MoreMachine hours Approx. 7,000
KILOMETERS N/A YEAR N/A BRAND N/A
LOCATION Queensland, Australia
MODEL SPM Weir TWS2250
-
Caterpillar CAT C11 Skid Mounted Engine with Integrated 800 Litre Diesel Tank ($39,500 ex GST) (sale-ehub3976)For Sale$39,500.00Make: Caterpillar Model: C11 Hours: 17,316 - With Integrated 800 Litre Diesel Tank - Dyno Test Results and ECM Available 350 HP 1,800-2,100 Complete Package with Control Panel and Starter and Alternator Dimensions; Length: Overall 250 cm (Take off 50 cm if you relocate Air Cleaner) Height to top of Valve Cover (Engine): 120 cm To top of Pre-Cleaner: 180cm To top of Muffler: 220 cm Width: 110 cm (Radiator) Skid Mounted Engine Location: Australia Learn MoreMachine hours 17,316
KILOMETERS N/A YEAR N/A BRAND Caterpillar CAT
LOCATION Australia
MODEL C11
-
2016 Safe-T BHA STS R1 Skid Mounted Jack Up Drill Rod Sloop ($120,000 ex GST) (sale-ehub3973)For Sale$120,000.00Make: Safe-T Model: BHA STS R1 Year: 2016 - Surplus to requirements Skid Mounted Jack Up Drill Rod Sloop Location: Tasmania, Australia Learn MoreMachine hours N/A KILOMETERS N/A YEAR 2016
BRAND N/A
LOCATION Tasmania, Australia
MODEL Safe-T BHA STS R1
-
4,000 Litre Skid Mounted Tank ($4,500 ex GST) (sale-ehub3964)For Sale$4,500.00Capacity: 4,000 Litres Skid Mounted Tank Location: Queensland, Australia Learn MoreMachine hours N/A KILOMETERS N/A YEAR N/A BRAND N/A
LOCATION Queensland, Australia
MODEL 4,000 Litre
-
Hydramaster 2000 Cable Tool Drill Rig Mounted on 1998 International Acco 4x2 Truck & Tri Axle Trailer ($99,000 ex GST) (sale-ehub3957)For Sale$99,000.00Rig Make: Hydramaster Model: 2000 - Fully Tooled & Spares - Recently painted Truck Make: International Model: Acco Year: 1998 KM's: 506,309 Type: 4x2 Engine: Cummins 300 HP Gearbox: 9 Speed Tri Axle Trailer - Near New - Set up for cable tool equipment Condition: Good Truck Mounted Cable Tool Drill Rig Tri Axle Trailer Location: Queensland, Australia Learn MoreMachine hours N/A KILOMETERS 506,309
YEAR 1998
BRAND Hydramaster
LOCATION Queensland, Australia
MODEL 2000
-
2011 Hanjin D&B 1070CP Skid Mounted Air Compressor ($92,500 ex GST) (sale-ehub3953)For Sale$92,500.00Make: Hanjin Model: D&B 1070CP Year: 2011 Hours: 3,443 Engine: Hyundai D6CC Power: 1,800 RPM / 530 HP Skid Mounted Air Compressor Location: Western Australia Learn MoreMachine hours 3,443
KILOMETERS N/A YEAR 2011
BRAND Hanjin
LOCATION Western Australia
MODEL D&B 1070CP
-
2x Reconditioned Gardner Denver GD PZ-7 Skid Mounted Bare Mud Pumps ($USD73,150 each) (sale-ehub3952)For Sale$0.00Make: Gardner Denver Model: PZ-7 - Reconditioned but not fully rebuilt Quantity: 2 Skid Mounted Bare Mud Pumps Location: Canada Learn MoreMachine hours N/A KILOMETERS N/A YEAR N/A BRAND Gardner Denver
LOCATION Canada
MODEL PZ-7
-
Air Research ARC 1809/1310 1,800 CFM / 900 PSI Skid Mounted Booster ($110,000 ex GST) (sale-ehub3924)For Sale$110,000.00Make: Air Research ARC Model: 1809/1310 Hours: 900 Engine: Detroit 8V92TA Power: 210 HP Weight: 2,400 kg 1,800 CFM 900 PSI Dimensions Length: 1,900 mm Width: 1,500 mm Height: 2,050 mm Skid Mounted Booster Location: New South Wales, Australia Learn MoreMachine hours 900
KILOMETERS N/A YEAR N/A BRAND Air Research
LOCATION New South Wales, Australia
MODEL 1809/1310
-
2020 Atlas Copco E-Air V1100 VSD Skid Mounted Air Compressor ($70,000 ex GST) (sale-ehub3914)For Sale$70,000.00Make: Atlas Copco Model: E-Air V1100 VSD Year: 2020 Hours: 2,405 Skid Mounted Air Compressor Location: Queensland, Australia Learn MoreMachine hours 2,405
KILOMETERS N/A YEAR 2020
BRAND Atlas Copco
LOCATION Queensland, Australia
MODEL E-Air V1100 VSD
-
S Reps 750 Gear Package ($8,000 ex GST) (sale-ehub3900)For Sale$8,000.00Includes; - 2x Complete Hammers (1x with a Hole Opener) - 1x Hammer in parts (Can Assemble with New Casing) - 17x Various Sized Shrouds (Mostly New) - 10x Bits (5x New & 5x Had One Run but Nearly New) - 7x Hammer Tubes - 4.5" Inch Remet to Metzke Hammer Adaptor and Inner Tubes - Various Other Spares S Reps 750 Gear Package Location: Western Australia Learn MoreMachine hours N/A KILOMETERS N/A YEAR N/A BRAND N/A
LOCATION Western Australia
MODEL See Description
-
Epiroc D65 Drill Rig Cyclone Unit ($6,000 ex GST) (sale-ehub3875)For Sale$6,000.00Make: Epiroc Model: D65 - Unit off a Eprioc D65 Blast Hole Drill Rig Cyclone Location: Western Australia Learn MoreMachine hours N/A KILOMETERS N/A YEAR N/A BRAND Epiroc
LOCATION Western Australia
MODEL D65
-
Gardner Denver FXXDFA Skid Mounted Mud Pump ($49,500 ex GST) (sale-ehub3819)For Sale$49,500.00Make: Gardner Denver Model: FXXDFA Hours: 2,261 - Diesel Driven Skid Mounted Mud Pump Location: Queensland, Australia Learn MoreMachine hours 2,261
KILOMETERS N/A YEAR N/A BRAND Gardner Denver
LOCATION Queensland, Australia
MODEL FXXDFA
-
Gardner Denver 5x10 Skid Mounted Mud Pump ($49,500 ex GST) (sale-ehub3817)For Sale$49,500.00Make: Gardner Denver Model: 5x10 Hours: 33 - Diesel Driven Skid Mounted Mud Pump Location: Queensland, Australia Learn MoreMachine hours 33
KILOMETERS N/A YEAR N/A BRAND Gardner Denver
LOCATION Queensland, Australia
MODEL 5x10
-
Gardner Denver PAH Skid Mounted Mud Pump ($29,500 ex GST) (sale-ehub3815)For Sale$29,500.00Make: Gardner Denver Model: PAH Skid Mounted Mud Pump Location: Queensland, Australia Learn MoreMachine hours N/A KILOMETERS N/A YEAR N/A BRAND Gardner Denver
LOCATION Queensland, Australia
MODEL PAH
-
2021 Kaishan KS150R Water Well Drill Rig + 2021 Kaishan KSC-550/14.5K Air Compressor & 1998 Hino Truck Package ($88,000 ex GST) (sale-ehub3782)For Sale$88,000.00Rig Make: Kaishan Model: KS150R Year: 2021 Hours: 150 - Water bore drilling for tight access Air Compressor Make: Kaishan Model: KSC-550/14.5K Year: 2021 Hours: 218 Truck Make: Hino Year: 1998 Tare: 6,700 kg GVM: 15,000 kg Water Well Drill Rig Air Compressor Truck Package Location: Queensland, Australia Learn MoreMachine hours 150
KILOMETERS N/A YEAR 2021
BRAND Kaishan
LOCATION Queensland, Australia
MODEL KS150R
-
Edson Versadrill 300 Drill Rig Mounted on Toyota Landcruiser Ute ($125,000 ex GST) (sale-ehub3781)For Sale$125,000.00Rig Make: Edson Model: Versadrill 300 Year: 1996 Engine: Hatze - 6x6 Multidrive Technology - Rotation head MR260 Rotation hollow spindle, single speed, dial in, rotation head around 120 rpm - Winching gear on back of mast for hollow augering - Can do diamond drilling if you were to change the hydraulic motor - Dump Mast - Near New Hydraulic Pump - 4x Leveling Jacks - Currently doing 80mtr holes at 4.5” - Client used to aircore with it, but currently set up doing mud - Used to do a lot of Geotech work, 6” hollow augering - Southern Cross Mud pump on the side - 3.2 mtr Stroke - 3 mtr Rods - Extension arm to run 6mtr casing into the ground Ute Make: Toyota Model: Landcruiser Year: 1990 KM's: 107,000 Ute Mounted Drill Rig Location: Western Australia Learn MoreMachine hours N/A KILOMETERS 107,000
YEAR 1996
BRAND Edson
LOCATION Western Australia
MODEL Versadrill 300
Filter