Search results for: 'skid pit rand hire ll'

Make: Caterpillar Model: C15 Year: 2006 Hours: 1,533 • 440 HP @ 2,100 RPM • 1482LB-FT @ 1,400 RPM • Air to Air intercooled • 12 Volt (We can covert to 24 Volt if required) • SAE #1 flywheel housing multi fit industrial flywheel. • If required, we can supply and install a Caterpillar Air Compressor to the motor which runs off the auxiliary drive. The motor has been removed from the unit and fully workshop inspected and run up under load on the Dyno, results are as follows: Workshop inspection: • Intake manifold clean. • Cylinder head and rocker gear clean, no moisture or sludge, tune ok. • Turbocharge in nice condition, no excessive shaft play. • Camshaft in nice condition, no pitting • Crankshaft in good condition (Standard) • Main bearings and Con rod bearings in good condition – minimal wear • Crankshaft end float within spec Load test Report • Oil pressure: Cold Idle 70psi / Cold Top Revs 85psi / Hot Idle 50psi / Hot Top Revs 75psi • Water temps: Top Radiator 92 degrees. Bottom Radiator 69 degrees. • Thermostat opened and engine recovered correctly. • Turbocharger boost: 23 PSI @ 2,100 RPM • Breathing/ Blow by: 20 mm @ idle 30 mm @ 1,200 RPM 50 mm @ 1,350 RPM. 120 mm @ 1,800 RPM. • Smoke condition: small amount of black on startup, none at idle and very small white under full load. Skid Mounted Engine Location: Queensland, Australia Learn More

Make: Tulsa Triplex Model: TT-560 Engine: Caterpillar CAT C15 Skid Mounted Mud Pump Location: New Zealand Learn More

Make: Baoji Oilfield Machinery Model: F-800 Skid Mounted Mud Pump Location: New Zealand Learn More

Rig Model: ZJ50D/3150 Year: 2012 Mast Model: JJ315/45-K6 Substructure Model: DZ3159-S Drawworks Model: JC50D Power: 1,500 HP Rotary Table Model: ZP-375 Full Opening: 37.5” Inch Rotary Speed: 300 RPM Mud Pump Power: 1,600 HP Stroke: 120 RPM Working Pressure: 5,000 PSI Quantity: 2x Mud Tank Shaker Tank: 25 CuM Intermediate Tank: 40 CuM Suction and Mixing Tank: 20 CuM Solids Control - 3x Shale Shaker - 1x Mud Cleaner - 1x Centrifuge Drill Rig Location: Japan Learn More

Make: SPM Weir Model: TWS2250 Year: 2022 (Reman Rebuild) Hours: Approx. 7,000 Engine: Caterpillar CAT C32 (Rated @ 1,350 HP) Transmission: Allison 8000 Series Auto (DP8962R) Dimensions; Length: 9,135 mm (Overall) Width: 2,505 mm Height: 2,615 mm (On Ground) Height: 4,280 mm (Raised) Weight: 20,000 kg - When raised has enough height for a trailer of 1,500 mm to drive underneath Skid Mounted Jack Up Frac Mud Pump Location: Queensland, Australia Learn More

Make: SPM Weir Model: TWS2250 Year: 2022 (Reman Rebuild) Hours: Approx. 7,000 Engine: Caterpillar CAT C32 (Rated @ 1,350 HP) Transmission: Allison 8000 Series Auto (DP8962R) Dimensions; Length: 9,135 mm (Overall) Width: 2,505 mm Height: 2,615 mm (On Ground) Height: 4,280 mm (Raised) Weight: 20,000 kg - When raised has enough height for a trailer of 1,500 mm to drive underneath Skid Mounted Jack Up Frac Mud Pump Location: Queensland, Australia Learn More

Make: Caterpillar Model: C11 Hours: 17,316 - With Integrated 800 Litre Diesel Tank - Dyno Test Results and ECM Available 350 HP 1,800-2,100 Complete Package with Control Panel and Starter and Alternator Dimensions; Length: Overall 250 cm (Take off 50 cm if you relocate Air Cleaner) Height to top of Valve Cover (Engine): 120 cm To top of Pre-Cleaner: 180cm To top of Muffler: 220 cm Width: 110 cm (Radiator) Skid Mounted Engine Location: Australia Learn More

Make: Safe-T Model: BHA STS R1 Year: 2016 - Surplus to requirements Skid Mounted Jack Up Drill Rod Sloop Location: Tasmania, Australia Learn More

Capacity: 4,000 Litres Skid Mounted Tank Location: Queensland, Australia Learn More

Make: Hanjin Model: D&B 1070CP Year: 2011 Hours: 3,443 Engine: Hyundai D6CC Power: 1,800 RPM / 530 HP Skid Mounted Air Compressor Location: Western Australia Learn More

Make: Gardner Denver Model: PZ-7 - Reconditioned but not fully rebuilt Quantity: 2 Skid Mounted Bare Mud Pumps Location: Canada Learn More

Make: Epiroc Model: Pit Viper 275 Part Number: 2657966534 Drill Rig Drive Shaft Location: Queensland, Australia Learn More

Make: Air Research ARC Model: 1809/1310 Hours: 900 Engine: Detroit 8V92TA Power: 210 HP Weight: 2,400 kg 1,800 CFM 900 PSI Dimensions Length: 1,900 mm Width: 1,500 mm Height: 2,050 mm Skid Mounted Booster Location: New South Wales, Australia Learn More

Make: Atlas Copco Model: E-Air V1100 VSD Year: 2020 Hours: 2,405 Skid Mounted Air Compressor Location: Queensland, Australia Learn More

Make: Mud Puppy Model: MP-255-2SC - Mounted on Hydraulic Jack Up Rod Sloop Mud Recycler Pump Location: New South Wales, Australia Learn More

Power (kW): 9-13, 30-50, 58-90, 150 Min. Flow (m3/hr): 1.5-6, 4.8-9, 8-15, 15-24 Throw (m): 30-50, 70-100, 120-150, 250 Oscillation (Deg): 0-360 Throw Angle (Deg): -5 to +45 - Stockpiles - Mine Blast Dust - Conveyor Discharge Chutes - Dust Hoppers - Crusher Machinery - Loading and Unloading Trucks - General Pollution - Airborne Dust - Construction Sites - Odor Control and Management Dust Suppression Location: Queensland, Australia Learn More

Model: OIE187 Cannon Fan: 425,000 m3/hr / Dual Fiber Glass PAG Impeller Discharge Hose: 1.5" Inch & 500 PSI High Pressure Pump: 7-8 Bars Discharge Fan Power: 130 kW Pump Power: 55 kW Pump Flow: 150 m3/hr Evaporation Rate: 24.98 lps @ 60% Daily Operating Time: 10 Hours + - SS Ring with Nozzles - Spiral Nozzle SS316 - Fan Safeguard Mesh - Control Panel Generator Make: Shanghai Stamford Brushless Engine: Dongfeng Cummins Control System: HGM6110 Large Screen Radiator: Engine Standard Matching Fuel Tank: 1,000 Litres Battery: 2x Camel 12V Weight: 6,000 kg approx. - Waste Water Handling - Dewatering Process - Tailing Dams - Water Production - Rainstorm Water Clearance Water Evaporator Location: Queensland, Australia Learn More

Make: Globe Power Model: LUY400-25 / GP400-25 Year: 2018 (Unit 1) & 2019 (Unit 2) Working Pressure: 15 - 25 bar Engine: Cummins QSZ 13-C500-30 Dimensions; Length (with Towing Device): 4,710 mm Length (with Horizontal Tow-Bar): 6,120 mm Width: 2,100 mm Height: 2,570mm Weight (Full Tank): 7,000 kg Portable Screw Wheel Mounted Air Compressor Location: Western Australia Learn More

Rig Make: UDR Model: 650 Hours: 9,202 - Commissioned Mid 2023 - Onboard PTO Driven Air Compressor - New water pump - New fan belts - New radiator core - Recent service with oil & new filters - New rod & piston seals to main feed Ram - New Dump Mast Ram - New rods & seals to mast raise rams - New side shift ram - New break out ram - New rod crane raise ram - New hydraulic valve blocks in control cabinet for main pump & secondary pump controls - New micro control fine feed controller - Replaced majority of gauges with new - New main rotation shaft seals & speedy sleeves - New main rotation torque control cartridge - New hammer oiler pump - New seats & O rings in majority of valve banks Air Compressor - New Air / Oil separator filter - New Oil stop valve - New Castrol Aircoil 68 synthetic oil - New filters - Recently been serviced by Midcoast Compressors Truck Make: MAN Year: 1997 KM's: 200,000 Type: 8x8 Transmission: Recon 18 Speed Gear Box - Kevrek 1500 Hiab Crane with Winch & Umbilical Cord Remote - Radiator back flushed - New Water Pump - New Fan Belts - New brake boosters on every wheel - New four way valve - New valve on brake pedal - Rebuilt Truck Compressor - New air on drivers seat - New air valves on diff locks / cross locks - New clutch, fly wheel & pressure plate - New bearings & seals in Dana drive box - New oil pump on Dana drive box - New universals on tail shafts - New ram on power steering - New tyres all around - All ball joints on truck replaced that were needed, or new rubbers on them - Recently passed Pit Inspection - 7 months Rego as Plant - No need for overhang permits; within length Truck Mounted Drill Rig Location: New South Wales, Australia Learn More

Make: Gardner Denver Model: FXXDFA Hours: 2,261 - Diesel Driven Skid Mounted Mud Pump Location: Queensland, Australia Learn More